Iwata Hoses, Manifolds, Etc

Iwata 10' Straight Shot Airbrush Hose is made of a polyurethane material which is twice as strong and 1/3 the weight of conventional braided air hoses. The attached Iwata airbrush fitting and 1/4" compressor fitting use O-rings which form leak-proof seals when attached. O-rings which form leak-proof seals when attached.

Iwata Adaptor to connects an Iwata airbrush to a Paasche, Badger and Thayer & Chandler air hose.

Iwata Adaptor Set connects Thayer & Chandler, Aztek, Badger and Paasche airbrushes to an Iwata brand air hose.

Release your airbrush from the air hose with the Iwata QuickFit Quick Disconnect Set. The QuickFit air hose adapter screws onto the air hose and stops the flow of air until the QuickFit airbrush adapter, screwed onto the airbrush, is clicked into place. Simply push down on the QuickFit air hose adapter to release the airbush.

Two and 3-way valve assemblies are ideal for splitting air from a single air source into multiple gun setups

Valves are leak-proof

With 1/4" male connectors

1/4" Treaded Fittings are used for connecting air hoses, regulators and multiple valve Assemblies to air source.

Essential for optimizing the performance of both the compressor and the airbrush. Attach either directly to the air source or can be placed inline between two airhoses. A high-quality 5-micron filter is used to remove any potential moisture particles. Consists of Regulator, Gauge (see F A700DH below, Moisture Filter ( See F A500DH below) adapters and Teflon tape. With Standard 1/4" fittings

Optimize performance of both the compressor and airbrush. A high-quality 5-micron filter is used to remove any potential moisture particles. Includes adapters and Teflon tape. With Standard 1/4" fittings.

Regulator and pressure gauge, Piston type pressure regulator. Gauge displays 0-100 psi incremented by 2 psi marks, consists of Regulator, Gauge, Adapters and Teflon tape. With Standard 1/4" fittings

Attaches directly onto the Iwata airbrush, this filter is the final defense to deliver clean, dry air to your airbrush. miniature in size, the super-fine 5-micron filter element performs like a full-size filter separator, Clear filter bowl allows a visual inspection of built-up moisture and is evacuated through a spring loaded release valve - without taking the filter off the airbrush. comfortable in the hand, acts as a handle on the airbrush to relieve muscle tension. Fits all Iwata airbrushes only

Thread Sealant Tape, 1/2" x 260" is a white PTFE (Teflon) tape that ensures a tight seal on any of your threaded fittings. It's mostly used for an airtight seal on your compressor output where you screw on your airbrush hose. It's a must for any air-powered tools!